Die Protection Sensor Interface Remote Die Box

The six (6) channel remote die box allows you to quickly change out the die sensors by using either plug connectors or Banana jacks. Provides +24VDC power to active sensors and monitors the status (PNP or NPN).

To order the Die Protection Sensor Interface Remote Die Box, order part number 53-450.

Part Number 53-450 includes:

Six (6) channel remote die box
Individual Channel Indicators
Cable - 45' quick disconnect (12 conductor) minimizes wiring installation time
Power supply is included to power sensors - 24VDC at 2.5 AMP

Indicator LED's

GREEN = NPN

RED = PNP

Banana Jack:

Passive GND sensors. When used you must jumper Pin 1 to 3 on Lumberg receptacle (female) (i.e. NPN only)

Installation

Apply 120vac L & N to Brown & RED/White stripe, Earth GND to RED & Shield wires.

Attach your Die Sensors to the Jacks. Wire the Die# out Pins to the Die inputs of your control.

Connect the Violet Ground wire to the Ground of your control so they are common.

If you use the built in 24vdc power supply, you may also be required to disable other 24vdc sources and use this one only.

Active PNP or NPN Sensors

Pin	Description
1	Jumper to Pin 3 if NPN, to Pin 4 if PNP
2	Sensor Output (NPN or PNP)
3	+24VDC from Die Box power supply
4	Ground from Die Box power supply

Shown view from solder end of plug

Enclosure:

NEMA 12, 13, IP54 painted steel (blue)

Dimensions:

8" (203mm) Height
6" (152mm) Wide
3.5" (89mm) Deep

45' of 16 Pin Circular Connection Cable

Pin	Wire Color	Description
1	BRN	120VAC L input
2	N/C
3	RED	Earth Ground
4	ORG	+24v out (from power supply)
5	YEL	+24v out (from power supply)
6	GRN	Die #6 output
7	Shield	Case Ground
8	N/C
9	BLU	Die #5 output
10	VLT	Ground
11	GRY	Die #2 output
12	WHT	Die #1 output
13	BLK	Die #3 output
14	BK/WT	Die #4 output
15	RD/WT	120VAC N input
16	N/C

Remote Die Box

Print this page

Need a Quote? Contact our Sales Department >>

Need Tech Support? Contact our Engineering Department >>

Bookmark Pressroom Site