Welcome to www.pressroomelectronics.com

Sales: (800) 937-4334
       Service: (630) 443-9343
 

 

 

Pressroom Electronics US Manufacturer of Press Controls

 
 
 

PCS-2000 Overview

The Model PCS-2000 Control System is completely prewired and ready for installation. System supplied complete with a well marked terminal strip for easy, safe, and accurate electrical interface to the various punch press components. Due to the hybrid design characteristics, a main power disconnect switch and magnetic motor starter can be supplied in the same control panel.

Customer to specify operator control location (photo below displays operator controls on panel door).

Our ordering/proposal sheet will allow you to configure your system exactly how you want it.

PCS 2000

NEMA 12 Enclosure

System Start Guarded Push Button (Air and Power Interlock)

System Stop Unguarded Push Button

System On Indicator Light

• Plain English messages for status and system self-diagnostics

• Automatic Continuous Set Up Push Button - This prior action push button must be operated to set-up the press for continuous operation. Once depressed, the operator has a preset length of time in which to depress both palm buttons concurrently to initiate operation in the continuous mode.

Time-Based Brake Monitor

Ground Fault Detector - Oil tight push to test type wired to continuously monitor press grounding whenever control power is on.

Continuous Arm Timer

Fused Secondary Pressure Clamp Terminals

Hand/Foot Mode Two position keyed selector for hand or foot mode initiation.

Transformer To reduce voltage from 480/240VAC to 120VAC secondary. Consult factory for 208 or 550 volt system.

Interrupted stroke provision

Keyed Mode Selector Off-Inch-Single- Continuous Four position keyed lock selector switch for supervised selection of mode of operation of the press. When in the inch mode, the operator cannot hold or tie one run button down and use the other button to inch the press with one hand operation. Both buttons must be depressed concurrently. Microinching and Automatic External Trip optional.

Resolver Transducer & Cabling
(supplied with 30' connector cabling standard)

Resolver

  

Print this Page Print this page

Pressroom eNewsletter
Subscribe to our mailing list and you will receive information on new products, Trade Show appearances and answers to your questions.

Need a Quote? Contact our Sales Department >> 

Need Tech Support? Contact our Engineering Department >>

Pressroom Electronics