Main Screen
The Main Screen allows for Job Selection and Naming, Parts, and Batch Count.    

Job:00
Parts: 000000
Batches: 000000
Angle: 000 SPM: 000   

Brake Monitor
In RUN Mode, the screen displays the Last Stop Time (in mSEC) and Last Dwell angle (in degrees).  

Last Stop Time= 000
Last Dwellº = 000   

In PROG mode, the original screen is displayed but with the Dwell angle added to the bottom line of the screen.  

Warn= 000 Fail= 000
Motion Det= 0.0 sec
90º - 270º test
Dwell= Time= 000   

Counter
The PressCam 8 Junior provides four types of counters: Stroke, Batch, Quality, and Part. When programmed, a counter will increment each time a part is ejected from the machine. When the programmed value is met, the controller will initiate an action.  

Strokes: 000000
Parts: 000000 /1
Batch size: 000000
Quality: 000000   

Servo Feed
Each PressCam 8 Junior job stores individual Servo Setup information and outputs through the RS-232 every time the unit is powered up, after you exit from the Servo Setup screen and after a job change. The Servo Setup screen can be accessed only while in PROG mode.  

Speed 1-100: 000
Accel 1-100: 000
MPC 1-100: 000
Feed Len.: 000.000   

Press Utility
This screen allows you to program the following settings: speed compensations, minimum speed, maximum speed, clear job, top dead center, PC link, and set password.  

Speed comp: 000
Min= 000 Max= 000
ClrJob SetTDC
PCLink Pasword 000   

Limit Switches
The following screen monitors the status of all six relay outputs as well as displays the current crank angle.   

LS1 LS4
LS2 LS5
LS3 LS6
ANGLE: 000 MONITOR  

Cyclical Outputs   

S CLS-OPN CLS-OPN
LS1 000-000 000-000
LS2 000-000 000-000
LS3 000-000 000-000  

S CLS-OPN CLS-OPN
LS4 000-000 000-000
LS5 000-000 000-000
LS6 000-000 000-000  

Cycle Delay & Hold Outputs   

DLY CY HLD CY
LS4 000 000
LS5 000 000
LS6 000 000  

Timed Outputs   

STRT ANG HLDmSEC
LS4 000 0000
LS5 000 0000
LS6 000 0000