PressCam 8 Junior--Operator Screens

Main Screen The Main Screen allows for Job Selection and Naming, Parts, and Batch Count.		Job: 00 Parts: 000000 Batches: 000000 Angle: 000 SPM: 000
Brake Monitor In RUN Mode, the screen displays the Last Stop Time (in mSEC) and Last Dwell angle (in degrees).		Last Stop Time= 000 Last Dwellº = 000
In PROG mode, the original screen is displayed but with the Dwell angle added to the bottom line of the screen.		Warn= 000 Fail= 000 Motion Det= 0.0 sec 90º - 270º test Dwell= Time= 000
Counter The PressCam 8 Junior provides four types of counters: Stroke, Batch, Quality, and Part. When programmed, a counter will increment each time a part is ejected from the machine. When the programmed value is met, the controller will initiate an action.		Strokes: 000000 Parts: 000000 /1 Batch size: 000000 Quality: 000000
Servo Feed Each PressCam 8 Junior job stores individual Servo Setup information and outputs through the RS-232 every time the unit is powered up, after you exit from the Servo Setup screen and after a job change. The Servo Setup screen can be accessed only while in PROG mode.		Speed 1-100: 000 Accel 1-100: 000 MPC 1-100: 000 Feed Len.: 000.000
Press Utility This screen allows you to program the following settings: speed compensations, minimum speed, maximum speed, clear job, top dead center, PC link, and set password.		Speed comp: 000 Min= 000 Max= 000 ClrJob SetTDC PCLink Pasword 000
Limit Switches The following screen monitors the status of all six relay outputs as well as displays the current crank angle.		LS1 LS4 LS2 LS5 LS3 LS6 ANGLE: 000 MONITOR
Cyclical Outputs		S CLS-OPN CLS-OPN LS1 000-000 000-000 LS2 000-000 000-000 LS3 000-000 000-000 S CLS-OPN CLS-OPN LS4 000-000 000-000 LS5 000-000 000-000 LS6 000-000 000-000
Cycle Delay & Hold Outputs		DLY CY HLD CY LS4 000 000 LS5 000 000 LS6 000 000
Timed Outputs		STRT ANG HLDmSEC LS4 000 0000 LS5 000 0000 LS6 000 0000